XPR-10 Series Two-Post Lifts 54 P/N 5900951 — Rev. D — May 2019
To install an Arm Restraint Gear on a Lift Arm:
1. Find the Lift Arm, Arm Restraint Gear, three Bolts, three Washers, and three Split-Lock Washers.
2. Determine whether the Lift Arm is a ‘left’ or ‘right’ Lift Arm.
3. Turn the Arm Restraint Gear so that the L is facing up if the Lift Arm is a ‘left’ or the R is facing up if
the Lift Arm is a ‘right’.
4. Put the Arm Restraint Gear into place over the holes in the Lift Arm.
5. Put one of the Split-Lock Washers and Flat Washers onto a Bolt, then push that Bolt down
through one of the holes in the Arm Restraint Gear and into the appropriate hole in the Lift Arm.
6. Using an appropriate tool, lightly tighten the Bolt into place.
You want the Arm Restraint Gear to stay in place, but you also want to leave a little play in it. This
makes it easier to mesh the Arm Restraint Gear and the Gear Stop when you are installing the Lift
Arm into a Lift Head.
7. Repeat Steps 5 and 6 for the other two Bolts.
The Lift Arm is ready to be installed into the Lift Head.
To Next Page
Loading...
