XPR-10 Series Two-Post Lifts 65 P/N 5900951 — Rev. D — May 2019
9. Repeat the process, this time raising the Lift, engaging it on a Safety Lock position, taking it off the
Safety Lock position, and then lowering it back down to the ground.
Again, follow the instructions in Raising a Vehicle and Lowering a Vehicle to safely raise
and lower a Vehicle on the Lift, including engaging it on its Safety Locks.
10. If the Lift is working without shaking, moving erratically, or squeaking, there is no need to repeat
the procedure.
If the Lift is shaking, moving erratically, or squeaking, repeat the procedure one more time.
If you continue to have issues, refer to Troubleshooting for assistance.
11. When the Lift is on the ground and the Vehicle is on all four tires, move the four Lift Arms to their
full drive-through positions.
12. Drive the Vehicle out.
13. With no Vehicle on the Lift Arms, press and hold the Up button on the Power Unit.
The Lift Arms start rising.
14. Have another person push up the Safety Shutoff Bar until it triggers the Microswitch.
The Lift Arms should stop rising.
If the Lift Arms do not stop rising when the Microswitch is triggered, this means the Microswitch is
either not installed correctly or not wired correctly. Return to the sections of this manual where
installation and wiring of the Microswitch is described to find and fix the problem.
⚠ CAUTION Do not put the Lift into normal operation until you have confirmed that triggering the
Microswitch stops the Lift Arms from rising.
Review Final Checklist Before Operation
Make sure these things have been done before putting the Lift into normal operation:
• Review the Installation Checklist to make sure all steps have been performed.
• Make sure the Power Unit is getting power from the power source.
• Check the Hydraulic Fluid reservoir; it must be full of approved Hydraulic Fluid or automatic
transmission fluid.
You can harm the motor by running it without enough fluid.
• Check the Hydraulic System for leaks.
• Make sure both Posts are properly plumbed, shimmed, and stable.
• Check to see that all Anchor Bolts are correctly torqued.
• Apply light axle grease to the inside of the Posts where the Slide Blocks move.
• Make sure both Carriage Bolts are in place and tightened near the top of both Posts.
• Make sure all Cables are properly positioned in their Sheaves.
• Make sure all Cable Sheave retaining pins and/or clips are secure.
• Make sure both Safety Assemblies are connected and working normally.
• Make sure that all Safety Locks are clear and free.
• Make sure an Operational Test has been done.
Leave the Manual
Make sure to leave the Installation and Operation Manual with the owner/operator.
To Next Page
Loading...
Need help?
General
