25 - 26
STORAGE
Always store your vehicle in a cool, dry place and, if
necessary, protect it against dust with a porous
cover.
Short-term
Long-term
Before storing your vehicle for several months:
1. Change engine oil.
Inflation pressure and tire tread should be regularly
checked. In order to ensure maximum safety and
longer service life, inflation pressure requires more
frequent routine check.
Tire Pressure
Insufficient tire pressure will not only accelerate
wearing, but also have bad impact on driving stability
such as making turning difficult. However, too high
pressure will reduce the contact area between tire
and ground, thus causing slipping or even getting out
of control. Tire pressure should be kept in the stan-
TIRE
dard range. Adjust the tire pressure under a "cold"
condition.
TIRE INFORMATION
COLD TIRE PRESSURE
[FRONT] 190kpa(1.90kgf/cm
2
) [REAR] 210kpa(2.10kgf/cm
2
)
!
Do not use a fuse or bulb of a higher amperage
rating than recommended to avoid causing
extensive damage to the electrical system and
possibly a fire or problems.
12V/55W/55W
12V 2W
12V 3A
LED
LED
LED
Turn light
Headlight bulb
Horn
Meter Light
Taillight bulb
City light
X
O
X
2. Lubricate drive chain.
3. Drain fuel in fuel tank .Install the fuel tank cover
again.
4. Detach the spark plug and add one teaspoon of
(15~20cm
3
) clean engine oil to cylinder. and install
the spark plug again.
5. Remove the battery. Keep the battery in proper
place which can avoid freezing and the direct
sunlight. Charge the battery or examine the
electrolyte level(if equipped with lead-acid battery).
6. Clean and dry the vehicle. Wax the surface of the
paint.
7. Inflate tire to the required pressure. Put the
vehicle on a block to make two tires off the ground.
8. Cover the vehicle (no plastic or coating material)
and keep it in the place consistent temperature and
low humidity. Do not keep your vehicle under direct
sunlight.
Use the vehicle after storage
1. Take off the cover and clean the vehicle. Change
engine oil if you keep your vehicle for more than four
months.
2. Examine the electrolyte level and charging as
needed. Install the battery.
3. Wash away the anti-rust agent in fuel tank, and
add new petrol into fuel tank.
REPLACING THE FUSES AND BULBS
The fuse is beside the battery. Frequent blowing of
fuse indicates short circuit or over loading. Contact
with the authorized dealer for proper repairing.
Use the fuses for the same specification as indicated.
10A
15A
15A
15A
Power Locks
Fan
Fuel Pump
ECU1
To Next Page
Loading...
Need help?
Engine Specifications
Weight and Dimensions
