Benelli TRK 702 User Manual

6 - 11
Periodic maintenance and adjustment
EN
6
To change the engine oil (with or wi-
thout oil lter cartridge replacement)
1. Place the vehicle on a at surface and
keep it upright.
2. Start the engine, warm it up for several
minutes, and then turn it o.
3. Place a suitable container under the en-
gine to collect the used oil.
4. Remove the engine oil ller cap, the en-
gine oil drain bolt and its gasket to drain
the oil from the crankcase.
1
1. Engine oil drain bolt
NOTE
Skip steps 5–7 if the oil lter cartridge is
not being replaced.
5. Remove the oil lter cartridge with an
oil lter wrench.
1
1. Oil lter cartridge
6. Apply a thin coat of clean engine oil to
the O-ring of the new oil lter cartridge.
E
NOTE
Make sure that the O-ring is properly se-
ated.
7. Install the new oil lter cartridge with
an oil lter wrench, and then tighten it to
the specied torque with a torque wren-
ch.
Tightening torque:
Oil lter cartridge:
15 N·m
8. Install the engine oil drain bolt and its
new gasket, and then tighten the bolt to
the specied torque.

Benelli TRK 702 Specifications

General

Displacement	698 cc
Bore x Stroke	83 mm x 64.5 mm
Compression Ratio	11.6:1
Fuel System	Electronic fuel injection
Transmission	6-speed
Final Drive	Chain
Seat Height	825 mm
Fuel Tank Capacity	20 liters
Engine Type	Liquid-cooled, 4-stroke, 2-cylinder
Maximum Torque	68.2 Nm @ 6, 250 rpm
Front Suspension	Upside-down telescopic fork
Rear Suspension	Monoshock, adjustable
Front Brake	Dual discs
Rear Brake	Single disc
Front Tire	110/80 R19
Rear Tire	150/70 R17
Weight	220 kg