3 - 11
Instrument and control functions
EN
3
Handlebar switches
Left
1
2
3
4
1. Horn button
2. Turn signal switch
3. Dimmer / switch
4. ENTER / SELECT button
5. High beam asher button
Horn button
Press this button to sound the horn.
Turn signal switch
To signal a right-hand turn, push this swi-
tch to . To signal a left-hand turn, push
this switch to . When released, the swi-
tch returns to the center position.
To cancel the turn signal lights, push the
switch in after it has returned to the cen-
ter position.
Dimmer / switch
Set this switch to for the high beam
and to for the low beam.
Select button
Short press SELECT button to set the mul-
tifunction display Trip A / Trip B.
Press the button for at least 3 seconds to
reset Trip A / Trip B.
If the mobile device is connected with the
multifunction display, the SELECT button
will allow to answer an incoming call.
Enter button
When the vehicle is stationary , the multi-
function menu can be accessed by short
pressing the ENTER button.
If the mobile device is connected with the
multifunction display, a call can be answe-
red by pressing the ENTER button.
High beam asher button
It is used to attract the attention of other
road users in case of danger. When the
high beam is on, the function is inactive.
Right
1
2
3
1. Run / Start switch
2. Hazard switch
3. Electric ignition button
Run / Start switch
To crank the engine with the starter, set
this switch to , see page 5-1 for starting
instructions prior to starting the engine.
Set this switch to to stop the engine in
case of an emergency.
Hazard switch
With the ignition key set to use this
switch to activate the hazard lights
(simultaneous ashing of all direction in-
dicators).
The emergency lights are used in case of
emergency, to advise the other road users
5
To Next Page
Loading...
Need help?
General
