June 2004 - 9507EI/5
1-10
2 to 9 Tonne Dumper Instruction Manual
Driving Controls
The range of dumpers have a common driving position and
controls for all models up to 3 tonne capacity. The 4, 5, 6, 7 and
9 tonne capacity models have a shuttle torque converter
transmission whereby an electric switch on the gearlever is used
in place of a clutch pedal to enable gear changes to be made, and
an electric forward/reverse selector is provided to give the
machine a common range of speeds in forward and reverse.
The driver is centrally positioned with the gear lever immediately
in front. The handbrake is located to drivers right, on seat support.
Clutch, footbrake and accelerator pedals are located in standard
automotive format.
The tipping of the skip is controlled from the driving position by
a lever operating the hydraulic control valve; which is located
adjacent to the drivers right hand.
Brake
Pedal
Engine Stop
Lister 2 and 3
Tonne
Engine Start Key
2 to 9 Tonne on Side of Dash
Except Lister
2 & 3 Tonne Lister on Front of Dash
Clutch Pedal
2 to 3 Tonne
Only
Forward & Reverse
Switch 5, 6, 7 & 9
Tonne
Accelerator
Pedal
Handbrake
Lever
Skip Control Lever
(see Skip Uses
section)
Engine Stop
Deutz 5 and 6
Tonne
Steering
Wheel
Drive
Interupt
Switch
Gear Lever
4, 5, 6, 7 & 9
Tonne
Dash
Panel
Gear
Lever
Driving Controls
To Next Page
Loading...