vi
Safety Notes
June 2004 - 9507ES/5
WARNING
Observe the Following Points to Prevent Damage to the Machine
z Always replace hoses, couplers and other parts with parts supplied or recommended by Benford - NEVER USE SPARE
PARTS OF INFERIOR SPECIFICATION.
z Never allow unqualified people to perform repairs on the machine.
z Never overfill the engine oil or fuel tank.
z If a hose bursts, stop the engine immediately - ALWAYS replace with a hose of the correct specification.
z Do not start the engine if you cannot see the hydraulic oil level in the sight gauge.
z Follow the engine starting instructions in this manual and on the machine.
z If you see oil leaking report it and get it fixed immediately.
z Make sure the correct fuel, oils and grease is used.
z Do not operate the machine unless it is safe to do so. Remember to check for overhead obstructions while driving.
z Never use the machine for purposes other than those it was manufactured for.
z Always ensure workmates are aware of your work plan.
z Ensure all tyres are serviceable before using the machine.
z Never cross inclines greater than those stated in this manual.
z Never drive the machine on to unstable ground or close to trenches, holes etc.
z Do not operate the machine if it is damaged, improperly adjusted or not completely and correctly assembled.
z Establish a training programme for all operators to ensure safe operation.
SAFETY SYMBOLS
Safety symbols are used in these instructions to bring attention to actions that may cause personal injury or damage to
the equipment. Always observe these symbols, they are included for your safety and for the protection of the power unit.
This symbol identifies an action that requires particular attention and / or care.
This symbol identifies an action that may be dangerous if performed incorrectly.
This symbol identifies a topic where further information is available.
Additional Safety and Warning Notes are Included in the Following Manual Pages
General Safety Notes
To Next Page
Loading...