BenQ LU9750 - Page 56

English
56
• Lens Control
Select this function to open Lens Control menu for adjustment of Zoom, Focus, or Shift. You
can use the ENTER button to switch the Zoom / Focus or Shift menu. Use
▲
or
▼
to adjust
zoom and vertical shift of the lens, or use
◄ ►
to adjust focus and horizontal shift of the lens.
• Lens Memory
This projector supports Lens Memory function, Lens shift, Zoom and Focus memory can be
stored in the projector up to 10 sets. You can load the stored memory setting to set up the
lens automatically.
Select Lens memory 1~10 :
ENTER key to Save/Load. Press
►
to switch Load/Reset state. CLEAR key to Reset.
• Center Lens
This is the lens calibration function, the projector calibrates the lens shift, focus and zoom
parameters for the precise lens memory function. After performing this function, the lens will
be moved to the center position as factory default setting.
Note:
• There are two default center positions for UST (Ultra Short Throw) Lens and non-UST Lens, make sure Lens Type
setting is correct before performing this function.
• If an UST lens is installed, remove the support kit of the UST lens before performing Center Lens. After all the
settings of the lens control are completed, then replace the support kit to x the UST lens.