Connection 23
Connecting the touch module
Connect the TOUCH-USB port on the display to the USB port of a computer using
the supplied touch USB cable. Then connect the video input port on the display that
corresponds to the TOUCH-USB port to the video output port on the computer. The
touch module of the display supports easy Plug-and-Play operation. There is no need to
install additional drivers on the computer.
• Avoid blocking the touch screen frame (where sensors are located) when initiating the touch
module.
• It is highly recommended that you connect the display to the PC or laptop directly. Avoid
connecting the display to a face plate device which may cause failures in touch operations.
• If any ghost image occurs, please try to un-plug and then re-plug all USB cables. If the failure
image still exists, use another USB type B to A cable.
TYPE-C HDMI TOUCH-USB PUBLIC-USB3.0
To Next Page
Loading...
