24 Operation
Shutting down the projector
1. Press / and a confirmation message will appear
prompting you. If you don't respond in a few seconds,
the message will disappear.
2. Press / a second time. The power indicator
flashes orange, the projection light source shuts down,
and the fans will continue to run for approximately 90
seconds to cool down the projector.
3. Once the cooling process finishes, the power indicator
becomes a steady orange and fans stop. Disconnect
the power cord from the power outlet.
• To protect the light source, the projector will not respond to any commands during the cooling process.
• Avoid turning on the projector immediately after turning it off as excessive heat may shorten lamp life.
• Lamp life results will vary depending on environmental conditions and usage.
To Next Page
Loading...
