21 Operation
4. If you are prompted for a password, press the arrow keys to enter a 6-digit password. See
Utilizing the password function on page 23.
5. Switch all of the connected equipment on.
6. The projector will search for input signals. The current input signal being scanned appears.
If the projector does not detect a valid signal, the message “No Signal” will continue
displaying until an input signal is found.
You can also press SOURCE to select your desired input signal. See Switching input signal
on page 25.
Step 3:
Specify 3D Keystone, and choose to activate Auto
Vertical Keystone.
For more information about keystone, see
Correcting keystone on page 17.
• Please use the original accessories (e.g. power cord) to avoid possible dangers such as electric shock
and fire.
• If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds
before energizing the light source.
• The Setup Wizard screenshots are for reference only and may differ from the actual design.
• If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the
message “Out of Range” displayed on the background screen. Please change to an input signal which is
compatible with the projector's resolution or set the input signal to a lower setting. See Timing chart on
page 48.
• If no signal is detected for 3 minutes, the projector automatically enters saving mode.
To Next Page
Loading...
