BenQ TK710 - Page 24

24 Operation
Entering the password recall procedure
1. Press and hold OK for 3 seconds. The projector
will display a coded number on the screen.
2. Write down the number and turn off your
projector.
3. Seek help from the local BenQ service center to
decode the number. You may be required to
provide proof of purchase documentation to
verify that you are an authorized user of the
projector.
Changing the password
1. Go to the Advanced menu - System > Security Settings > Password. Press OK. The
Password page appears.
2. Highlight Change Password and press OK.
3. Enter the old password.
• If the password is correct, another message “Input New Password” appears.
• If the password is incorrect, the password error message will appear, and the message
“Input Password” appears for your retry. You can press BACK to cancel the change or
try another password.
4. Enter a new password.
5. Confirm the new password by re-entering the new password.
Disabling the password function
1. Go to the Advanced menu - System > Security Settings > Password > Power On Lock and
press OK and / to select Off. The message Input Password appears.
2. Enter the current password.
• If the password is correct, the OSD menu will disappear. You will not have to enter the
password next time turning on the projector.
• If the password is incorrect, the password error message will appear, and the message
Input Current Password appears for your retry. You can press BACK to cancel the
change or try another password.
Though the password function is disabled, you need to keep the old password in hand should you ever need
to re-activate the password function by entering the old password.
Please write down the recall
code, and contact BenQ
Recall Code:
Recall Password
Return