BenQ TK710 - Page 34

34 Menu operation
3. Main menu: Display
Structure
Function descriptions
Menu Options
Aspect Ratio Auto/4:3/16:9
Auto Source Search Off/On
Source Rename HDMI-1/HDMI-2
3D
3D Mode
Auto/Frame Sequential/
Frame Packing/Top-Bottom/
Side by Side/Off
3D Sync Invert Disable/Invert
HDMI Settings
Signal Format Auto/Limited/Full
Equalizer HDMI-1/HDMI-2 Auto/1/2/3/4/5
EDID HDMI-1/HDMI-2 Enhanced/Standard
HDMI Device
Control
Off/On
Power On Link
Off/From Device
Power Off Link
Off/From Projector
4K Upscaling
Off/On
Reset Display Reset/Cancel
Menu Descriptions
Aspect Ratio
There are several options to set the image's aspect ratio depending on your
input signal source.
• Auto: Scales an image proportionally to
fit the projector's native resolution in its
horizontal or vertical width.
• 4:3: Scales an image so that it is
displayed in the center of the screen with
a 4:3 aspect ratio.
• 16:9: Scales an image so that it is
displayed in the center of the screen with
a 16:9 aspect ratio.
Auto Source
Search
Allows the projector to automatically search for a signal.
Source Rename
Renames the current input source to your desired name.
On the Source Rename page:
1. Press OK to display the on-screen keyboard.
2. Press / / / to select each desired digit/letter, and press OK to
confirm each input.
3. Repeat the step above and when done, press BACK.
4. Press to highlight Commit.
5. Press OK and the source name changes.
15:9 picture
4:3 picture
16:9 picture