129
Error Code
Type
Operation ASCII Note
Read
Error Code
<CR>*error=report#<CR>
The error code can be shown via RS-232 port. Record the latest 3 times error
information. It should report the following item.
Note 1: A reading time(N seconds) is necessary for this function at power saving
mode(standby power < 1W).
Note 2: Power saving mode(standby power < 1W) is in the condition of …………..
Item Description
1
Error Item
2
Lamp Usage Hour
3
Inlet Temp
4
Outlet Temp
5
Fan 1 speed
6
Fan 2 speed
7
Last Source
Note: The error item could be discussed after project kicked off.
Software Version
Type
Operation ASCII Note
Rea
d
Software Version
<CR>*sver=?#<CR>
Standby, power on
Auto keystone
Type
Operation ASCII Note
Writ
e
Enable Auto keystone
<CR>*ak=on#<CR>
power on
Writ
e
Disable Auto keystone
<CR>*ak=off#<CR>
power on
To Next Page
