BenQ W700 - Software and Firmware Management; System Requirements and Software Installation

34
Software/Firmware Upgrade Process
Projector USB Drivers Installation Guide
The document is to describe the Windows application software “Flash-Tool” for projector firmware.
Its main purpose is to provide a detailed procedure of upgrading the application software of a DLP
TM
projector.
The system requirement and the installation procedure of “Flash-Tool” are also included in the document.
System Requirement
1. IBM compatible PC.
2. Windows XP-SP2 operating system.
Install Flash-Tool to PC
Run the “Digital Zoom Projector Flash Tool Vx.y.msi”, it will automatically launch the USB
drivers update. Following are the dialogues of the Driver Install process as below.
(Step 1) This is the first page of install dialog.
Click on the “Next” button to continue, or Click on the
“Cancel” button to cancel the installation.
(Step 2) Driver Destination:
Click on the “Change” button to change the default
directory for saving the driver file somewhere else, or
Click on the “Back” button to return to the previous
page, or Click on the “Cancel” button to cancel the
installation
Note:
The user must have administrative privileges on the target computer in order to
install your driver.
The installation target directory must not write protected.
User also required having the basic knowledge of Windows application installation.
Attention: This utility is for DLP
TM
DDP2000/3020/2230/243X series projector only.