ATIS TOP - Fancier
AFTER SWITCHING ON
28
HB_TOP_ZUECHTER-E_22.doc
Gantner Pigeon Systems GmbH
7.5 A Race or Training Flight in Progress
When a race is going on and the device has finished its search for antennae it goes over to
the following initial status
The device constantly displays the number of the pigeons registered until now.
As long as no key is pressed the ATIS-TOP remains in this
initial status
. Date and time are
permanently actualized.
7.6 Antenna Failure
Mind:
If there is a modification in the number of connected loft antennae during the
process of registration (e.g. by an error in the cabling) the ATIS-TOP immediately starts a
new search for antennae.The new result is displayed in the following way: the number of
connected antennae is flashing accompanied by a beep.
The process of registration is not interrupted by this! Don`t forget, however, that the
arriving pigeons are only registered on the antennae that are connected resp.indicated!
It`s only when the number of connected or found antennae is correct again or when the
device is switched off and on again (e.g. by plugging out and replugging the transformer)
that the flashing of the display and beeping will stop.
TOP
arrived pigeons: 12
01.12.96 14:56:22
active antennae: 02
To Next Page
Loading...
Need help?
General
