Beretta POWER MAX User Manual

4
1 GENERAL INFORMATION
1.1 General Safety Information
b
After removing the packaging, check the condition and com-
pleteness of the supply. If there are any problems, contact the
company
B that sold the equipment.
b
This product must be installed by a legally qualied heating
engineer. On completion of the installation, the installer must
issue the owner with a declaration of conformity conrming that
the installation has been completed to the highest standards
in compliance with the instructions provided by B in this
instruction manual, and that it conforms to all applicable laws
and standards.
b
This product must only be used for the purpose for which it is
designed and made, as specied by
B. B declines all
responsibility, contractual or other, for damage to property or
injury to persons or animals caused by improper installation,
adjustment, maintenance or use.
b
In the event of a water leak, disconnect the thermal module
from the main power supply, shut off the water supply and
promptly notify the Technical Assistance Centre B or pro-
fessionally qualied personnel.
b
Periodically check that operating pressure in the water circuit
is over 1 bar but below the maximum limit specied for the boil-
er. If this is not the case, contact Technical Assistance Centre
B or a professionally qualied heating engineer.
b
The following operations shall be necessary if the thermal mod-
ule is not used for a long period of time:
- Switch the boiler OFF at the control panel
- Turn the main system switch "off"
- Close the fuel cock and heating circuit water cock
- Drain the central heating circuit if there is any risk of freezing.
b
Maintenance must be performed on the thermal module at
least once a year.
b
This manual is an integral part of the appliance and must
therefore be kept with care and must ALWAYS accompany the
thermal module, even when it is passed on to another owner
or user or transferred to another installation. If it is lost or dam-
aged, please contact your local Technical Assistance Centre
B for a new copy.
b
This manual must be read carefully so as to ensure the correct
and safe installation, operation and maintenance of the appli-
ance. The Owner must be adequately informed and trained on
how to operate the appliance. Make sure that he/she is familiar
with all the information required for safe system operation.
b
The thermal module, before being connected to the hydraulic
system, the gas network, and the electrical system, may be
exposed to temperatures ranging from 4°C to 40°C. After it can
activate the Frost Protection function, it can be exposed to tem-
peratures ranging from -20°C to 40° C
b
Regularly check that the condensate drain is free from obstruc-
tion.
b
We recommend cleaning inside the exchanger once a year,
extracting jet and burner and removing any installation debris
by suction. This operation should be done by personnel from
the Technical Assistance Centre only.
1.2 Precautions
The operation of any appliance that uses fuel, electrical power and
water demands that a number of fundamental safety precautions be
respected:
a
Do not allow children or inrm persons to operate the system
unsupervised.
a
It is forbidden to use electrical devices or equipment, such as
switches, appliances, etc. if there is a smell of gas or un-burnt
products. If so:
- Ventilate the room, opening doors and windows
- Close the fuel shut-off cock
- Report the fault immediately to the B's Technical Assis-
tance Centre or a professionally qualied heating engineer.
a
Do not touch the boiler while barefoot or wet.
a
Any technical or cleaning activity is forbidden before discon-
necting the appliance from the main power supply by switch-
ing the system's master switch and the appliance's main
switch to the "OFF" position.
a
Do not tamper with or adjust the safety or control devices with-
out prior authorisation and instructions from the manufacturer.
a
Do not plug or block the condensate drain outlet.
a
Never pull, disconnect, or twist the electrical cables coming
from the appliance even if it is disconnected from the mains
electricity supply.
a
Do not obstruct or restrict the vents in the room where the boiler
is installed. Adequate ventilation is essential for correct com-
bustion.
a
Do not expose the appliance to weather elements (without us-
ing the dedicated accessory). It has been designed for indoor
use.
a
Do not switch off the appliance if the outdoor temperature may
drop to below ZERO (frost hazard).
a
Do not leave ammable containers and substances in the
room where the device is installed.
a
Do not dispose of packaging material into the environment, or
leave it within the reach of children, since it can become a po-
tential hazard. Dispose of packaging material in compliance
with applicable legislation.
a
Do not activate the thermal module without water.
a
Individuals without specic qualications and skills are not al-
lowed not remove the thermal module's casing.

Beretta POWER MAX Specifications

General

Brand	Beretta
Model	POWER MAX
Category	Heating System
Language	English