Safety
Operating manual, Dumper – 3012 PLUS
41 - 131
28 April 2015
Bergmann Maschinenbau GmbH & Co. KG
Maintenance and repair work must only be performed when the engine is at a standstill. Remove the
ignition key to prevent unauthorised restarting of the dumper, and set the parking brake lever to the
parking position (see fig. 5-2, item 2).
Before carrying out any maintenance or repair work, park the dumper on level ground with the necessary
load capacity. Lower the trough to a suitable position and/or secure it with the support provided. To do
this, remove the trough support (see fig. 5-3 and 5-4) from its holder below the trough and swivel it onto
the auxiliary frame.
Secure the joystick for trough operation against inadvertent operation by engaging it in its bottom position
(see fig. 5-2, item 1).
For repair work, only use proper lifting gear with an adequate carrying capacity. Do not stand under
suspended loads.
Before mounting or dismantling attachments and other component parts, secure them with adequate
suspension devices or prop supports in order to prevent unintentional moving, slipping or dropping. This
also applies to changes to the installation length of components.
Ensure that all tools, lifting tackle and other auxiliary devices are in proper working order.
To Next Page
Loading...
