Bernini M42148 - Self-Watering Garden Feature

20
Self-Watering Garden Feature
Before placing the Flowerbud nial, make sure there are no dancing water fea-
tures attached to the water outlet in the fountain bowl and remove any other nial
decorations. Note: the LED lights will not be visible when using the Self-watering
Garden Feature.
Transplant potted plant into the garden bowl.
Before placing the garden bowl on to your fountain, make
sure to clean any loose soil from the bottom of the bowl
to reduce dirt in the fountain on rst use.
During rst use, some of the soil will transfer from the bot-
tom of the garden bowl into the fountain causing dirt to
show up in the bottom bowls.
After approximately three days of use, clean the fountain
bowl and the large bowl of debris and the loose soil will
stop transferring to the fountain, allowing the fountain to
run cleanly.
NOTE: THE SELF-WATERING GARDEN BOWL DOES
NOT LOCK INTO PLACE.
Using the Self-Watering System
Your self-watering aerating Garden Fountain is designed to adjust for dierent types of
plants depending on their water requirements.
For plants with a ample
water requirement, use no
spacer.
Plants with large water re-
quirements, use one spacer.
Plants with little water
requirements, use two
spacers.