23
Cleaning the Water Pump’s Parts
Water Pump Air Filters
After about six weeks of usage, you may want to clean the water pump’s lter and
impeller to keep your Bernini Fountain in tip-top shape.
Water Pump Impeller
The impeller inside of the water pump is what pushes water up through your fountain,
allowing you to enjoy the soothing sounds and wonderful sights of your Bernini Foun-
tain. After long periods of usage, this part will need to be cleaned to make sure your
fountain runs optimally.
Remove the front of
the water pump by
grabbing the sides of
the front panel and
pull it off the unit.
Remove the impeller
chamber cover. This
is tightly tted on to
the impeller chamber,
but will come off.
Remove the impeller
from its chamber.
Rinse the impeller
until all debris has
been removed. Then
replace the impeller
in the impeller cham-
ber, put the impeller
chamber back on
and then replace the
pump’s front panel.
Remove the front of the
water pump by grabbing
the sides of the front panel
and pull it off the unit.
Pull the water pump lter
from the front panel.
Wash the lters under
running water until debris
has been removed. Then
replace the lters and
pump’s front cover.
To Next Page
Loading...
