Bestop Trektop PRO - Section 5: Run Harness to Rear of Vehicle (Continued); Step 1: Tuck Carpet; Step 2: Connect at Rear

Section 5 Run Harness to Rear of Vehicle
Page 8
P8 - 54857 - Rev. A 0415
Installation Instructions - Trektop PRO Defrost Harness
© 2015 Bestop, Inc.
HardwareStep 1 Step 2
4-Door Vehicles:
Using the trim removal tool,
remove the trim fasteners indicated.
Save the fasteners to be reused when
reinstalling the trim panel.
Push the trim panel and the carpet back just
far enough to tuck the harness underneath
the door sill.
Step 1
Tuck the wire harness behind the door
sill and underneath the trim panel and
the carpet.
Step 2
Wiring Harness “B”
POWER LOAD GROUND
1
2
3
4
Trim
Removal Tool