EFL Operator Guide
System Interconnections
Part No. MAN/EN5103-0076 Page 17 of 34 Revision A (Jan 2014)
Connect the fiber LaserSpeed gauge to the fiber gauge breakout using one of
the DB25M-F cables. Connect the fiber LaserSpeed to the fiber gauge
breakout using the DB9M-F serial cable. The length of the DB9M-F serial
cable connected to the fiber gauge breakout should match the length of the
DB25M-F gauge cable. Connect the fiber gauge breakout to the
synchronization breakout using the DB9M-F serial cable. The length of this
cable must be specified at the time of purchase to according to the expected
distance between the fiber breakout and the synchronization breakout which is
located near the EFLTrak PC. This cable carries RS422 and synchronization
signals back to the synchronization breakout.
To Next Page
Loading...
