EFL Operator Guide
European Commission Requirements
Part No. MAN/EN5103-0076 Page 4 of 34 Revision A (Jan 2014)
European Commission Requirements
This equipment is intended for use in a heavy industrial environment. The equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to other
equipment. There is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to other equipment the user is encouraged to try to correct the interference by one or more of the following
measures:
- Re-orientate or relocate the equipment.
- Increase the separation between the pieces of equipment.
- Connect the pieces of equipment on separate mains circuits.
- Ensure that the relevant items of equipment are properly and securely earthed to a common earth point using adequately
sized cable or other means of connection.
Where supplied or specified, shielded interconnection cables must be employed with this equipment to ensure compliance with
the pertinent RF limits. Changes or modifications not expressly approved by the company could void the user’s authority to
operate the equipment.
This product has been rigorously tested to comply with the European EMC (Electromagnetic Compatibility) Directive. With
regard to this, Beta LaserMike recommends that any non-Beta LaserMike peripheral equipment is CE marked for the Heavy
Industrial environment (EN50082-2). Beta LaserMike also recommends that any cables not supplied by Beta LaserMike, but
used for powering Beta LaserMike equipment, be built using good EMC practices (i.e. cables with braided shield, and
connectors with 360 termination of the braid to a metal/metalised shell connector at both ends). If you have any questions
regarding this, contact the Beta LaserMike Service Department.
To Next Page
Loading...
