Beta LaserMike LASERSPEED 8000 - Page 53

LaserSpeed 8000/9000 I/O Module Instruction Handbook
Setup
Part No. 93342 / Drawing No. 0921-01516 Page 53 of 84 Revision E (Dec 2013)
Value
Type
0
AM7704 Displays:
Velocity, Length, Quality Factor, Status
1
AM8096 Displays:
Length, Elongation %, Velocity, Quality Factor,
Status
This setting must match the display type (defined by AM####) used with the
system.
~I / .I Parallel Port Configuration Settings
~I<CR> Read All Settings (with labels)
Example Response Format:
ParallelPort
ReadyFlag 1
StrobeFlag 1
DataFlag 1
AckMode 0
ReadyLn 1
Elongation 1
ElongRes 1
LenRes 1
VelRes 1
DisplayType 0
Set All Values
~I<R>,<S>,<D>,<A>,<L>,<E>,<ER>,<LR>,<VR>,<DT><CR>
.I<CR> Read All Settings (without labels)
Example Response Format:
1,1,1,0,1,1,1,1,1,0<CR>