Beta LaserMike LASERSPEED 8000 - Page 54

LaserSpeed 8000/9000 I/O Module Instruction Handbook
Setup
Part No. 93342 / Drawing No. 0921-01516 Page 54 of 84 Revision E (Dec 2013)
Where <R>, <S>, <D>, <A>, <L>, <E>, <ER>, <LR>, <VR>, and <DT> are as
follows:
Value
Description
Values
<R>
Parallel Port Data Ready
Output Polarity
0 – Active Low
1 – Active High (default)
<S>
Parallel Port Data Request
Input Polarity
0 – Active Low
1 – Active High (default)
<D>
Parallel Port Data Output
Polarity
0 – Active Low
1 – Active High (default)
<A>
Parallel Port Update Mode
0 – Data Ready Mode (default)
1 – Data Request Mode
<L>
Parallel Port Data Ready
Strobe Length
0-255
<E>
Parallel Port Elongation
Mode
0 – Disabled
1 – Enabled (default)
<ER>
Elongation Resolution
Multiplier values:
1 = Elongation x 1 (default),
0.1 = Elongation x 0.1
0.01 = Elongation x 0.01
0.001 = Elongation x 0.001
<LR>
Length Resolution
Multiplier values:
1 = Length x 1 (default),
0.1 = Length x 0.1
0.01 = Length x 0.01
0.001 = Length x 0.001
<VR>
Velocity Resolution
Multiplier values:
1 = Velocity x 1 (default),
0.1 = Velocity x 0.1
0.01 = Velocity x 0.01
0.001 = Velocity x 0.001
<DT>
Display Type
0 = AM7704
1 = AM8096