3
ADJUSTMENTS
30
GB
ADJUSTING FORK
ADJUSTING THE REBOUND
DAMPER
The hydraulic brake unit in extension
determines the behaviour in the extension
phase of the fork and can be adjusted us-
ing screw 1. Turning clockwise increases
the action of the brake in extension, while
rotating counter-clockwise decreases the
action of the brake in extension.
For standard calibration, refer to page
11.
1
ACCELERATOR
ADJUSTING THE IDLE SPEED
In order to perform this operation correctly,
we advise you to do it when the engine
is hot, connecting an electric revolution
counter to the spark plug wire. Then use
a screwdriver on register screw A to
calibrate the minimum with 1.100÷1.200
rpm.
HANDLEBAR ADJUSTMENT
The handlebar can be adjusted by rotating
it back and forth.
- To adjust the handlebar loosen screws 1.
- Position the handlebar according to
requirements.
- Tighten to the torque indicated.
1
20Nm
A
To Next Page
Loading...
