3
ADJUSTMENTS
32
GB
ADJUSTING THE SPRING
PRELOAD
To adjust the spring preload, use the pro-
cedure described below.
Loosen counter-ring 1, rotate ring 2 clock-
wise to increase the spring preload (and
consequently the shock absorber preload)
or anticlockwise to decrease it.
After obtaining the desired preload, turn
counter-ring 1 until it stops against adjust-
ing ring 2.
For standard calibration, refer to page
11.
NOTE: for movement of the rings use a
specific sector key with square pin
SUSPENSION ADJUSTMENT
ACCORDING TO THE
MOTORCYCLIST’S WEIGHT
The following table shows the approximate
calibration of the suspension adjustment
according to the motorcyclist’s weight.
2
1
w < 70 Kg 70 Kg < w < 80 Kg 80 Kg < w
Adjustment Adjustment Adjustment
Fork Shock absorber Fork Shock absorber Fork
Shock ab-
sorber
Standard Standard
+ 5 turns
preload
+ 1,5 turns
preload
+ 10 turns
preload
+ 3 turns
preload
To Next Page
Loading...
