Beta EVO 4T - Bleeding the Front Brake

4
CHECKS AND MAINTENANCE
44
GB
BLEEDING THE FRONT BRAKE
To bleed air from the front brake circuit,
proceed as follows:
•Removetherubbercap1 from the valve
2.
•Openthesumpcap.
•Insertoneendofatransparenttubeinto
a container.
•Pumpwiththebrakelever2/3timesand
keep the lever pressed.
•Unscrewthevalveandlettheoildrain.
•Ifarestillvisibleinthetuberepeatabove
operation until obtaining a continuous
outflow of oil within no air bubbles.
•Closethevalveandreleasethelever.
NOTE:
During this procedure, continuously top up
the brake pump thank to replace the oil that
is out flowing.
•Removethetube.
•Replacetherubbercap.
Close the oil reservoir cap.
1
2
WARNING:
The brake fluid is extremely corrosive. Take care not to spill it on the paintwork.
Wear appropriate protective clothing and protection gloves.
Keep coolant out of reach of children.
WARNING: Avoid any direct contact of the liquid with skin, eyes or clothing.
If this happens:
- with the eyes, rinse immediately with plenty of water and seek medical advice.
- with skin, immediately clean contaminated areas with soap and water. Change
clothing that is contaminated with liquid.
If liquid is swallowed, contact a doctor immediately.