Beta EVO 4T - Rear Brake Lining Control

4
CHECKS AND MAINTENANCE
47
GB
2 mm
NOTE:
During this procedure, continuously top up
the brake pump thank to replace the oil that
is out flowing.
•Removethetube.
•Replacetherubbercap.
Close the oil reservoir cap.
REAR BRAKE LINING CONTROL
In order to verify the wear condition of rear
brake is enough to view the caliper from
the back side, where is possible to glimpse
the brake lining tails which will have to
show a brake of 2 mm in thickness. If the
stratum is lesser let’s start replacing them.
NOTE:
Perform the check according to the times
shown in the table on page 61.
To replace, contact authorised Betamotor
customer service.
WARNING:
The brake fluid is extremely corrosive. Take care not to spill it on the paintwork.
Wear appropriate protective clothing and protection gloves.
Keep coolant out of reach of children.
WARNING: Avoid any direct contact of the liquid with skin, eyes or clothing.
If this happens:
- with the eyes, rinse immediately with plenty of water and seek medical advice.
- with skin, immediately clean contaminated areas with soap and water. Change
clothing that is contaminated with liquid.
If liquid is swallowed, contact a doctor immediately.