A
ON
OFF
STARTING THE ENGINE WHEN HOT
1 Put the gearbox in neutral.
2 Operate the hot start by pulling outward
the knob C (the red one)
3 WITHOUT opening the throttle, press the
kickstart lever progressively downwards,
avoiding violent strokes, to the bottom of
its travel.
4 Release the hot start after the engine has
run for some instants
STARTING WHEN THE BIKE HAS FALLEN
OVER
If the bike falls over, the carburettor float
bowl may empty.
1 Open manually the fuel tap by turning the
lever A clockwise (ON)
2 Put the gearbox in neutral.
3 Operate the Hot Start knob (C).
4 WITHOUT opening the throttle, press the
kickstart lever progressively downwards,
avoiding violent strokes, to the bottom of
its travel.
5 Close the fuel tap.
ADVANCE MAP CHANGE SWITCH
Using the switch shown in the figure, it is
possible to choose between two different
map for spark advance.
With the switch in position 1, “soft” map is
selected, more suitable for slippery terrain
and for a softer engine response.
With the switch in position 2, “hard” map
is selected, for a more aggressive engine re-
sponse: more suitable for dry conditions.
1
2
To Next Page
Loading...
Need help?
General
