AIR FILTER
To access the filter, simply unscrew the 5
locking screws (A) of the rear mudguard,
then proceed as follows:
Remove the mudguard by disconnecting 1.
the tail light cable.
Remove the filter frame and the filter by 2.
unscrewing the 2 screws (B).
Wash it with soap and water.3.
Dry it.4.
Moisten it with filter oil, removing any ex-5.
cess so that it does not drip.
If necessary, clean the inside of the filter 6.
box as well.
Proceed with reassembly. We recommend 7.
first assembling the frame on the filter.
Note
If the filter is very dirty, wash it first with petrol,
then with shampoo and water.
If the filter is damaged, replace it immediately.
Caution
After every intervention, check that nothing
has been left inside the filter box.
Clean the filter every time the vehicle is
used off-road.
A
B
To Next Page
Loading...
Need help?
General
