CHANGING THE ENGINE OIL
N.B. At each oil change, the mesh filters must be
cleaned and the paper filter replaced.
N.B. The oil change must be carried out when
the engine is at working temperature. Be careful
not to scald yourself with the hot oil.
After the engine has reached operating
temperature, switch the bike off and stand
it upright.
Unscrew the oil drainplug and let all the oil
flow out into a drain pan. Thoroughly clean
the magnet on the drainplug to get rid of
the metallic impurities that it has collected.
Unscrew the plug in the left-hand casing
and use pliers to extract the filter. Clean it
carefully and blow it through with compres-
sed air. Check for damage to the O-rings,
and replace them if necessary. Refit all the
parts and tighten the plug to 15 Nm.
To Next Page
Loading...
Need help?
General
