EasyManuals Logo

Beta Evo4t 300 User Manual

Beta Evo4t 300
38 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
betamotor.com
5
ENGLISH
What to do in an emergency
78
PROBLEM CAUSE CURE
THE ENGINE
WILL NOT START
Fuel feed system obstructed (pipes,
fuel tank, tap)
Clean out the system
Air filter excessively dirty Follow procedure on page 65
No current getting to the spar-
kplug
Clean or replace the sparkplug.
If the problem persists, contact one
of our dealers
Engine flooded
With the throttle closed, active the
Hot Start knob and operate the kick-
start lever repeatedly
Drained floatbowl
Operate the manual tap as described
on page 50
THE ENGINE
MISFIRES
Sparkplug with incorrect
electrode gap
Set the electrode gap correctly.
See note on page 64
Sparkplug dirty Clean or replace the sparkplug
Earthing fault Check insulation at kill switch
POOR FRONT
BRAKING
Pads worn, greasy or vitrified Follow procedure on page 67
Air or moisture in hydraulic circuit Follow procedure on page 60
POOR REAR BRAKING
Pads worn, greasy or vitrified Follow procedure on page 68
Air or moisture in hydraulic circuit Follow procedure on page 61

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Beta Evo4t 300 and is the answer not in the manual?

Beta Evo4t 300 Specifications

General IconGeneral
BrandBeta
ModelEvo4t 300
CategoryMotorcycle
LanguageEnglish

Related product manuals