Beta Rev 3 2006 - Rear Brake

59
GB
3
MAINTENANCE AND CHECKS
REAR BRAKEREAR BRAKE
REAR BRAKEREAR BRAKE
REAR BRAKE
CheckCheck
CheckCheck
Check
To check the rear brake for wear, simply
observe the caliper from the rear, where it
is possible to see the ends of the two pads.
These pads should have at least a 2 mm
Iayer of Iining. if this Iayer is thinner than
2 mm, replace the pads immediately.
Note: Note:
Note: Note:
Note: Observe the times given on the
chart on pag. 62 when performing the
check.
ReplacementReplacement
ReplacementReplacement
Replacement
To replace the pads, proceed as follows:
•Unscrew the screw A
•Make to slip the pads towards the sock
posterior (see arrow), favoring the spill-
age of the pads.
•Remove the pads and replace them
•To reassemble, proceed in the reverse
order. Apply “frenafiletti medio” to the
screw A.
If the brake disk is removed, applyIf the brake disk is removed, apply
If the brake disk is removed, applyIf the brake disk is removed, apply
If the brake disk is removed, apply
Loctite to the screws whenLoctite to the screws when
Loctite to the screws whenLoctite to the screws when
Loctite to the screws when
reassembling.reassembling.
reassembling.reassembling.
reassembling.