Beta Rev 3 2006 - Adjustment of Idling Speed; Check and Adjustment of Steering Gear

65
GB
4
ADJUSTEMENTS
ADJUSTMENT OF IDLING SPEEDADJUSTMENT OF IDLING SPEED
ADJUSTMENT OF IDLING SPEEDADJUSTMENT OF IDLING SPEED
ADJUSTMENT OF IDLING SPEED
In order to perform this operation
correctly, we advise you to do it when the
engine is hot, connecting an electric
revolution counter to the spark plug wire.
Then use a screwdriver on register screw
AA
AA
A to calibrate the minimum (1000 rpm).
ADJUSTMENT OF GAS CLEARANCEADJUSTMENT OF GAS CLEARANCE
ADJUSTMENT OF GAS CLEARANCEADJUSTMENT OF GAS CLEARANCE
ADJUSTMENT OF GAS CLEARANCE
Whenever the accelerator shows
unloaded travel exceeding 3 mm,
measured from the edge of the handle,
you should adjust it by means of
carburetor register
BB
BB
B.
CHECK AND ADJUSTMENT OFCHECK AND ADJUSTMENT OF
CHECK AND ADJUSTMENT OFCHECK AND ADJUSTMENT OF
CHECK AND ADJUSTMENT OF
STEERING GEARSTEERING GEAR
STEERING GEARSTEERING GEAR
STEERING GEAR
Periodically check the play in the steering
sleeve by moving the fork back and forth
as shown in the figure. Whenever you feel
play, adjust as described below:
•Unscrew the 4 screws
CC
CC
C
•Remove handlebar
DD
DD
D
•Loosen nut
EE
EE
E
•Take up the play by means of ring nut
FF
FF
F.
For reassembly. proceed in the reverse
order.
ADJUSTMENT AIRADJUSTMENT AIR
ADJUSTMENT AIRADJUSTMENT AIR
ADJUSTMENT AIR
It is advised from 1 1/2 to 2 1/4.