Beta RR 250 - Brake Pad Wear Inspection

3
CHECKS AND MAINTENANCE
39
GB
FRONT BRAKE LINING CONTROL
In order to verify the wear condition of front
brake is enough to view the pincer from the
bottom, where is possible to glimpse the
brake lining tails which will have to show
a brake of 2 mm in thickness. If the stratum
is lesser let’s start replacing them.
Note
Perform the check according to the times
shown in the table on
page 52.
WARNING
Failure to promptly replace the brake pads
can result in a considerable reduction of
the braking action and in damage to the
brake disc.
REAR BRAKE LINING CONTROL
In order to verify the wear condition of rear
brake is enough to view the pincer from the
back side, where is possible to glimpse the
brake lining tails which will have to show
a brake of 2 mm in thickness. If the stratum
is lesser let’s start replacing them.
Note
Perform the check according to the times
shown in the table on page 52.
WARNING
Failure to promptly replace the brake pads
can result in a considerable reduction of
the braking action and in damage to the
brake disc.
2
2