User Manual for PH Warming Cabinets Beverage-Air
Rev. 01/21Beverage-Air10
This is a cord-connected unit, and must be connected to
its own dedicated power supply. Check the dataplate on
the machine to conrm the voltage and per the dataplate
use the correct fuses or circuit breakers.
Note: Do not connect to GFI / GFCI outlets. Connection to that type of outlet can result in product loss due to unsafe
cabinet temperature when GFI device trips from moisture.
Power Cords
This 220 volt model is equipped with a power cord and type
6-20P plug.
If a power cord becomes damaged, it must be replaced
with the identical cord.
Follow All National and Local Codes
This Unit Must Be Grounded. Do not use extension cords
and do not disable or by-pass ground prong on electrical
plug.
Prior to use, the interior and exterior surfaces of the
cabinet should be cleaned thoroughly with warm water,
mild detergent, and a soft cloth. Apply with a dampened
cloth and wipe in the direction of the metal grain. Then
allow to air dry with the doors open. Only use a clean soft
cloth. See detailed cleaning instructions in the cleaning
and maintenance section
Initial Start Up
After the cabinet has been installed, leveled, and cleaned
as described above, refer to the following check list:
• Check for proper electrical hook-up.
• Check that all clearances are in line with the
aforementioned guidelines.
• Check that cabinet is level.
NOTE: Once the unit has been started and reaches proper
storage temperatures, it may be loaded with product. For
proper energy eciency and airow we recommend a
minimum1” clearance between product and side walls, 4”
clearance between product and ceiling, and 1” clearance
from the bottom of the unit.
ELECTRICAL
To Next Page
Loading...