Beverage-Air PH - Help Continued

User Manual for PH Warming Cabinets Beverage-Air
Rev. 01/21 Beverage-Air 23
Product load burning
or boiling
Product load is too close to heating
element
Rearrange product load so that it is not too close
to heating element(s).
Controller setpoint is too high Adjust controller setpoint to a lower setting.
Examples of holding times and temperatures are
within the operator's manual.
Product load becoming
soggy
Too much humidity or moisture inside
cabinet
Adjust or close internal venting/damper knob to
control moisture. Normally the internal venting/
damper should be open for products such as
breaded meats, sh, etc
Product load held too long time. Hold product load inside cabinet per
recommended time. Examples of holding times
and temperatures are on page 12.
Cabinet is noisy Part(s) loose Locate and tighten loose part(s)
Cabinet is not level Level cabinet by adjusting legs or shimming caster
Door won't close Hinge(s) may need slight adjustment Apply shim(s) to hinge until door seals properly
Controller Alarm &
Error
---- Refer to page 17 of manual. If problem( s)
persist,Codes contact the factory for further
assistance
HELP CONTINUED