Beverage-Air PH - Alarm Codes

User Manual for PH Warming Cabinets Beverage-Air
Rev. 01/21 Beverage-Air 17
Code Description LED Relay Reset Parameters involved to Enable alarm
E1 Probe Pb1 failure ON Active Automatic Ont, Oft
E2 Probe Pb2 failure ON Active Automatic Ont, Oft
E3 Probe Pb3 failure ON Active Automatic Ont, Oft
E4 Probe Pb4 failure ON Active Automatic Ont, Oft
E5 Probe Pb5 failure ON Active Automatic Ont, Oft
EL LINK2 probe failure ON Active Automatic Ont, Oft
Ei Virtual probe failure ON Active Automatic Ont, Oft
AH1 HIGH temperature 1 alarm ON Active Automatic SP1, Att,Afd,HA1,PAO,dAO,OAO,tA1
AL1 LOW temperature 1 alarm ON Active Automatic SP1, Att,Afd,HA1,PAO,dAO,OAO,tA1
AH2 HIGH temperature 2 alarm ON Active Automatic SP2, Att,Afd,HA2,PAO,dAO,OAO,tA2
AL2 LOW temperature 2 alarm ON Active Automatic SP2, Att,Afd,HA2,PAO,dAO,OAO,tA2
EA External alarm ON Active Automatic PEA, EAL
OPd Door open alarm ON not active Automatic PEA, tdO
Ad2 End of defrost due to time-out ON not active Automatic dE1, dE2, dAt
Prr Preheating alarm ON not active Automatic
E10 Clock alarm ON not active Automatic
HiP HIGH voltage alarm ON not active Automatic SPH, SPL, dFL, SoU
LoP LOW voltage alarm ON not active Automatic SPH, SPL, dFL, SoU
nPA General pressure switch alarm ON not active Automatic PEn, PEi
LPA High pressure switch alarm ON not active Automatic PEn, PEi
HPA Low pressure switch alarm ON not active Automatic PEn, PEi
PA General pressure switch alarm ON not active Manual PEn, PEi
ALARM CODES