BFT ECOSOL - MOTOR CONNECTIONS; SINGLE GATE OPERATION WIRING; DUAL GATE OPERATION WIRING

BFT PHOBOS BT AND
IGEA BT GATE
OPERATORS ONLY
When installing dual gate where the gates overlap (or has a lock mechanism), it is important that the
motor that needs to open first is wired to MOTOR 2 terminals.
During the open cycle, MOTOR 2 starts first (MOTOR 1 has a delayed open start). During the close
cycle, MOTOR 1 starts first (MOTOR 2 has a delayed close start).Both delays can be independently adjusted
from 1 to 29 seconds. Please refer to page
24
24 for further instructions.
When installing a single leaf gate operator, the motor leads must be wired to MOTOR 2 terminals and
LIBRA controller must be configured to single gate operation. Please refer to page 26 for further
instructions.
SINGLE GATE OPERATION
DUAL GATE OPERATION
MOTOR 2
OPENS FIRST
CLOSES SECOND
MOTOR 1
OPENS SECOND
CLOSES FIRST
USE 16 AWG OR BETTER, STRANDED WIRES
USE 16 AWG OR BETTER, STRANDED WIRES
MOTOR CONNECTIONS
17
www.BFTGateOpeners.com | (800) 878-7829