BFT ECOSOL - INITIAL PROGRAMMING PROCEDURES; ACCESSING THE PROGRAMMING MAIN MENU; CONFIGURING SINGLE MOTOR OPERATION; PERFORMING AUTOMATIC TORQUE ADJUSTMENT (AUTOSET)

SINGLE MOTOR OPERATION
From the main programming menu, scroll to LOGIC and press OK
Scroll down to 1 MOT ON and press OK
Press the button to switch to ON and press OK
Use the and buttons to navigate up or down the LOGIC Sub-menu
Press the and buttons AT THE SAME TIME to return to the MAIN MENU
THE PROGRAMMING MAIN MENU
Press the OK button twice to enter the programming MAIN MENU
Use the and buttons to navigate up or down the MAIN MENU
Press the and buttons AT THE SAME TIME to exit programming
AUTOMATIC TORQUE ADJUSTMENT (AUTOSET)
WARNING – Gate path must be free of all traffic and obstructions. The system will
automatically open and close the gate at full torque while performing the self-learning
adjustment. Failure to do so can result in property damage and/or bodly injury including
death.
Gate must be fully closed and operators must have the CLOSE limit triggered before starting
From the main programming menu, scroll to AUTOSET and press OK
Upon completion of the close cycle, the screen should display OK. Press OK to finalize the
process.
If KO is diplayed, check for unsual physical gate hardware resistance or incorrect installation
geometry and try again.
Use the and buttons to navigate up or down the MAIN MENU
Press the and buttons AT THE SAME TIME to exit programming
INITIAL PROGRAMMING26
www.BFTGateOpeners.com | (800) 878-7829