LED 2
LED 4
LED 3
RADIO LEARN BUTTON
PROGRAMMING DIP-SWITCH BANK
DIPSWITCH PROGRAMMING
●
Switch 1 – Must be turned on ONLY when secondary pair of
batteries is connected.
●
Switch 2 – Enables Quick Radio Programming
●
Switch 3 – Command relay delay (MUST BE TURNED ON)
●
Switch 4 – Command relay delay
LED LEGEND
LED2 – Libra programming jumper (JP14) on indicator
LED3 – (1 flash/sec) Learning transmitter as START input.
(2 flashes/sec) Learning transmitter as OPEN input.
(Steady) Hidden button learned.
(3 flashes) Low battery (below 24V)
LED4 – Charging batteries
RADIO LEARN BUTTON
PRESS ONCE – Initiates process of learning transmitters as
START input. LED 3 will flash @ 1/sec.
PRESS TWICE - Initiates process of learning transmitters as
OPEN input. LED 3 will flash @ 2/sec.
Refer to page 28 for further transmitter programming
instructions.
DELETING THE MEMORY
PRESS AND HOLD – Deletes all transmitters from memory. LED
3 will blink rapidly, then on steady.
Once it turns off, release the RADIO LEARN BUTTON.
JP 14 jumper
ECOSOL SETTINGS 21
www.BFTGateOpeners.com | (800) 878-7829
To Next Page
Loading...
