1
STEADY
BLINKING
PRESS AND HOLD THE ON
BUTTON UNTIL THE RED LED
TURNS ON STEADY
2
ENTER THE 4 DIGIT CODE FOR
CHANNEL 1 (DEFAULT=1111)
3
PRESS THE ON BUTTON. RED
LED MUST BE BLINKING
4
PRESS THE RADIO LEARN
BUTTON ON THE ECOSOL,
ONCE TO ENABLE THE
KEYPAD TO OPEN AND CLOSE
THE GATE -OR- TWICE TO
ENABLE THE KEYPAD TO ONLY
OPEN THE GATE
5
PRESS THE ON BUTTON. WAIT
10 SECONDS BEFORE
TESTING THE KEYPAD. REFER
TO T-BOX MANUAL FOR
INSTRUCTIONS ON HOW TO
CHANGE DEFAULT CODE
BLINKS
AND
TURNS
OFF
PROGRAMMING THE T-BOX (Not included)
PROGRAMMING THE MITTO
BACK OF TRANSMITTER
Physical hidden button
FRONT OF TRANSMITTER
Virtual hidden button
Both buttons at the same time
OR
1
PRESS THE RADIO LEARN BUTTON
ON THE ECOSOL, ONCE TO
ENABLE THE REMOTE TO OPEN
AND CLOSE THE GATE -OR- TWICE
TO ENABLE THE REMOTE TO ONLY
OPEN THE GATE
2
PRESS AND HOLD THE HIDDEN BUTTON UNTIL
THE RED LED TURNS ON SOLID
3
PRESS THE BUTTON WHICH
YOU WOULD LIKE THE GATE
TO OPERATE WITH. FOR
ADDITIONAL MITTOS, GO TO
STEP 2. WAIT 10 SECONDS
AFTER LAST TRANSMITTER
LEARNED TO TEST.
RADIO TRANSMITTERS28
www.BFTGateOpeners.com | (800) 878-7829
To Next Page
Loading...
