POWER UP THE CONTROLLER
Instal the jumper provided on both pins labeled JP14 on the Ecosol
interface board. As long as this jumper is in place the Libra UL-R
will be powered for the programming process
JP14
Use the LCD display and the 3 buttons on the upper right corner of the Libra UL-R to navigate and manipulate
the menu.
PRESS 2 TIMES TO ENTER THE MAIN PROGRAMMING MENU
USE THE AND BUTTONS TO SCROLL
UP AND DOWN THE MENU
USE THE BUTTON AS “ENTER” TO SELECT A MENU CHOICE
OR CONFIRM A PROGRAMMING ORDER
NAVIGATE THE PROGRAMMING MENU
PRESS AND AT THE SAME TIME TO EXIT PROGRAMMING
REMOVE JUMPER UPON PROGRAMMING COMPLETION
Failure to do so will result in rapid battery discharge
LIBRA UL-R PROGRAMMING22
www.BFTGateOpeners.com | (800) 878-7829
To Next Page
Loading...
