and magnet.Make sure the triangle marks is close to
each other.
5) Paste the transmitter and magnet separately on doors
or windows or any other open/close places with provided
double-sided tapes.
6) Done! Once the transmitter and magnet is separated
around 2cm by intruder ,the LED light in transmitter will
be on in Red. Alarm will be activated.
8.3 PIR Motion Sensor installation
Make sure the contact works properly before installing it.
1). Choose a suitable place for installation.
2) Fix the sensor
Fix the installation bracket on the wall with screws, then
fit the groove at the back of the sensor on the bracket.
You can adjust bracket angle to achieve the best
detection effect.
15 16
To Next Page