EasyManua.ls Logo

Bibene D3-1 - 12 DIY Solution Q & a; Tommys Office; Jennys Cute Cafe; Mollys Home

Bibene D3-1
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1) Remove the battery of main panel
2) Keep Long pressing without release until battery
are re-load & 10 times beep sounds firstly & 4 times beep
sounds emits again,Then release pressing. Done.
Note:
After Restore factory Setting, all sensors including
remote control are all deleted. The main panel is on
disarming status.
12. FAQ
12.1 Tommys Ofce
Tom:
I install LED 1 pair Door sensor for zone 1 where is my
ofce back door. I hope it will alarm immediately if
someone opens after i arm the system. And keeps it silent
after i disarm it. How to set zone 1 features?
LOVLOY Answer:
Set Zone1 to be Ordinary Mode.
1) Long press & key [1] immediately, then the LED
indicator of zone 1 on main panel will keep ashing,
means entering the process of setting of zone1.
2) Short press key [1] which means you choosed mode 1-
ordinary mode
3) Then short press key [1] which means you choosed no
arming delay
4) The main panel will emit a long beep sound that
indicates your setting is done.
5) Finally press to quit setting.
12.2 Jennys Cute Cafe
Jenny:
I run a small caf downtown.There are 2 important place,
Zone 1 is the warehouse back door which i never open,so
i hope it will alarm no matter i arm or disarm the system
when someone break in there. And the second important
area is the entrance of my caf(Zone2). While i am at the
work(Disarm), I it would prompt me with doorbell tone
when customer came in. While i go off work (Arm),it will
alarm with siren when some one break in . How to set ?
LOVLOY Answer:
Set Zone1 to be emergency Mode:
Long press & key [1] + short press key [2] + short
press key [1] + to quit.
Set Zone 2 to be Welcome Mode.
Long press & key [2] + short press key [4] + short
press key [1 or 2] + to quit
12.3 Mollys Home
Molly:
Im a housewife, i stay at home most of the time. The
balcony is my zone3, i need it alarm delay 30seconds
after arming, and keep silent after disarming. The gate is
my zone 4, i need it to be alarm with doorbell sound no
matter in the status of arm/disarm.How to set zone 3 and
zone 4 features?
19 20