3) Mount the PIR sensor in proper angle.
It’s recommended to mount it at height of 2.2m from
ground, and to be install LED
indoors in a corner as far as possible in order to obtain
the ideal detection range.
The sensitivity is optimal when the walk direction is
vertical to the infrared direction.Choose the best location
and angle according to the actual situation.
4) Pair sensor Installation Notices
-Avoid infrared detectors facing to glass windows or
doors;
Strong light will interferes with detection sensitivity.
What’s more, complicated situation such as traffic
flow,stream of people also should be avoided.
-Avoid infrared detectors facing to or close to heat/cold
sources
Heat/Cold sources, such as heaters, air
conditioner,microwave oven which may cause false
triggering.
-Avoid two PIR sensors placed in the same space.
There will be interference phenomenon caused by trigger
at the same time if several sensors install LED in same
place
-Avoid installing infrared detector at outside, and it’s only
for indoor use.
9. Change Disarm Password
1) Remove the battery of main panel
2) Keep Long pressing any digital number (except
000button) without release until battery are re-load & 6
times beep sounds & 2 times beep sounds emits,Then
release pressing. Now the 4 LED indicates are on.
Set 4 digital password (Every pressing on digital number
along with LED indicator flash 1time accordingly when
you are setting password ,if set password incorrectly or
l o n g i n t e r v a l , t h e m a i n p a n e l w i l l q u i t s e t t i n g
automatically. Then you need to re-set password)
3) Shot press to quit.Done.
10.Low Battery Prompt
When battery is in low power, the sound of main panel
becomes weaker and trail off, LED indicator becomes
weaker,either
11.Restore Factory Setting
17 18
To Next Page