28
075 22 10 36
100 22 10 36
135 22 10 36
175 22 14 46
200 27 14 46
235 27 17 65
280 27 17 65
300 36 17 110
June 2020
Installation, Operation and Maintenance Manual
MAN 564_EAC Rev. 2
Operation and Use
Section 3: Operation and Use
3.4 Calibration of Micro-switches (If Foreseen)
(Refer to Safety Instructions Manual for limit switch box)
!
WARNING
Refer only to technical documentation related to installed switch box model.
NOTICE
For mounting interface dimension of the Limit Switch box on the cover of the actuator,
please refer to TN1163V (for metric dimension) or TN1163VU (for imperial dimension).
NOTICE
Operate only the micro-switch corresponding to the direction of operation being carried
out, as clearly reported on the micro-switch. End of stroke microswitches should be
operated before the stop of the stroke of the actuator due to mechanical stops. Adjust
the relative cams properly.
c2
c1
c3
t
g
Hydraulic cylinder size Wrench c1 (mm) Wrench c2 (mm) Wrench c3 (mm)
Table 13.
Figure 30 Mechanical stop of the MHP cylinder
To Next Page
