Shenzhen Big Tree Technology Co., Ltd.
BIGTREETECH
26 / 26
Cautions
1. Do not attempt to hot-swap the TF card. Make sure it is properly inserted
before powering on the device.
2. We advise customers not to disassemble the device as they may not be
familiar with the internal structure, which can lead to internal circuit breakdown.
Any problems caused by disassembling will not be covered by compensation.
3. If you need to replace the core board, follow the replacement steps provided
(see "To Replace CB1 with CM4" section).
4. When wiring the SPI interface to the expansion module, pay close attention to
the silkscreen to avoid short circuits.
If you require additional resources for this product, please visit
https://github.com/bigtreetech/ to find them. If you cannot find the resources you need,
please reach out to our after-sales support team for assistance.
If you encounter any other issues while using this product, please don't hesitate to
contact us. We will provide careful answers to your inquiries. We also welcome any
feedback or suggestions you may have about our products, and we will consider them
carefully. Thank you for choosing BIGTREETECH. Your support means a lot to us!
To Previous Page
Loading...
Need help?
General
