18.
ENGLISH
TEMPERATURE FUNCTION:
IMPORTANT: It is not recommended to press buttons
while watch is fully submerged in water. Therefore
for water temperature readings, the MODE button
should be pressed out of the water and the watch
may be fully submerged after the button is pressed.
When in any application hold the MODE button to
enter the Temperature Gauge application.
The temperature reading will be shown in any ap-
plication as long as it is not on a SETTING STATE.
To enable or disable the reading, hold the MODE
button in any application. After 30 seconds a time out
will automatically close the application to save power
consumption.
The reading will show the value in Celsius rst for 3
seconds, and then in Fahrenheit for 3 seconds. This
will continue until exiting Temperature Gauge.
Temperature
sensor
Temperature
reading
To Next Page
Loading...